Back in 2001, when I first moved to Asheville, NC I had a 3,500 square foot house and my wife and I both had offices on different floors. Wi-Fi just wasn't cutting it, and while I used 10Base2 (a.k.a. thinnet) to connect routers and switches between floors there was no way to make it look good. So I started experimenting with power-line networking, and I haven't looked back.
The reason for that is that power-line networking makes use of your electrical lines to give you a de facto wired network. It gives you the range of a wired network without any of the mess or the need to run cable behind the walls.
Another useful feature, which I've used in every place I've ever deployed, is that you can use it as the backbone for your Wi-Fi network. So, for example, in my current small office/home office (SOHO), I use it to connect my three Wi-Fi access points (APs) to my master switch. With this I have both direct wired access from my main office to my server room and strong Wi-Fi over my entire property.
Power-line networking pros and cons in the real world
Why should you use power-line? Well, first and foremost, it's easy. There's usually no software setup; you just plug one unit into the wall socket, plug its Ethernet cable into your router or switch, plug the other adapter in near your remote PC, another router, or a Wi-Fi AP (access point), hook them up together, and ta-da, instant network.
Power-line also has far less latency than Wi-Fi typically does. That can be a real advantage if you play games on your network.
As I mentioned earlier, I often use power-line networking to hook up Wi-Fi APs and routers. There are two ways to do this. One is to simply use a power-line adapter that includes a Wi-FI AP or a router with Ethernet ports. For Wi-Fi, look to adapters such as NetGear's XAVNB2001, which includes a 802.11n AP and 200Mbps HomePlug AV200. For adapters that come with multiple Ethernet ports seek out the D-Link DHP-540 PowerLine AV 500 4-Port Gigabit Switch or the ZyXEL Powerline AV 500Mbps 4 Port Gigabit Switch Wall-plug Adapter with PLA4205 Powerline AV 500Mbps (PLA4225KIT) Both come with 4Gbps ports and support Powerline AV 500 for speeds of up to 500Mbps.
On the downside, besides being affected by your electrical wiring's quality, power-line networking can be messed up by some home appliances. In particular, electrical devices with a motor, such as vacuum cleaners and dryers, can slow down your network connection while they're in use.
You should also be careful of mixing and matching power-line equipment across vendors. In theory, one device of the same standard should work with another without any worries. In practice, it's a different story. In my experience the problem usually comes down to how each vendor implements security. I've usually been able to get them to work together by getting them on the same security page, but it's often not easy due to inadequate documentation.
That's it for the bad side of power-line networking. It really does just work and it extends your network with little fuss or muss.
Some power-line adapters to try
I've used all of these adapters either in my own SOHO or deployed them in other offices. There may better ones out there, but I know these work well.
When you start shopping for power-line adapters, you'll find that in your typical electronics store they come as pairs. That makes sense. You must have two to do anything with them. But, after you get the first pair, and you want to extend your network you will probably need to contact the vendor to order single units.
The ZyXel PLA4205 works well and supports both Gigabit Ethernet and Power-line AV 500. It's the fastest power-line device available on the market today that I've used. It, however, does not actually hit 500Mbps. The best I've seen out of this pair is 226Mbps. That's still more than fast enough for most practical purposes.
At a street price of $50 for one or $80 for the pair, it's also very affordable. The one drawback is it's also very big for this kind of device, making it tough to squeeze into tight places.
Almost as fast, is NetGear's Powerline 500Mbps 2-Port Adapter - Starter Kit (XAVB5602). Like the ZyXel, it's too darn big and it's not as fast as it should be. I've seen only 172Mbps out of it.
This NetGear device is also more expensive than the ZyXel. It runs for about $199 for a pair. I still like it for one good feature: It includes a pass-through socket so you don't lose a power outlet like you do with most Power-line network gear.
Finally, I like the ActionTec 500 AV Powerline Network Adapter - Single Port for tight places when you're on a budget. It only supports Fast Ethernet (100Mbps) on the Ethernet half so even though the power-line side supports Powerline AV 500 you can't even in theory get more than 100Mbps out of it. That said, it does get the most it can out of that 100Mbps, I've seen speeds of up to 73Mbps from these units.
Unlike the others, it's also compact and will fit into most cramped behind the desk spaces and at $40 per pair, you're not going to get more network bang for the buck. As long as you're not editing photographs or video over it, I think you'll find it more than fast enough for most of your office needs.
Whatever device you get, power-line networking will make your networking life much easier. I know it has mine! Enjoy!
For more details on how power-line networking works and the evolution of power-line networking standards, read the ITworld article "How and why to extend your network with power-line networking".
This story, "Getting Started with Power-Line Networking" was originally published by ITworld.